(Is it possible to) Correct value within app (with basic mathematical calculations)

[HansTis]

Is it possible to correct a Blynk value (in my case calibrating by adding +2) within the app formatting options or so? I know this can be done within my project software but the projectbox is mount high above the ground

[wanek]

afaik it is not possible.
what mcu are you using? with esp it is possible to flash firmware ota…

[Gunner]

I think “in App” calculations are planned… just not here yet.

Widget Nice to have

Nowadays i have three different hardwares using the same token but different virtual pins. With this configuration I can see all the information with only one App. The thing is that I would like to display a value that is the addition of V1 + V2 + V3, where each Virtual pin comes from different Hardware. The workaround to do this, as far as i know is using a brige that reads information from different HW, makes calculations and then sends to Blynk. But i think it would be much simple to have a …

[HansTis]

Thanks, using a Wemos Mini Pro so OTA.

[HansTis]

Hope you’re right, can’t wait