Hi there, I am a new Blynk user and I could not make it work properly.
My code:
#include <WiFi.h> //Inclusão das bibliotecas
#include <WiFiClient.h>
#include <BlynkSimpleEsp32.h>
char auth[] = "4C4enZftisYd0ud6QbmUfuO2M6LNx87o"; //Inclua aqui o token recebido por email
char ssid[] = "JRFiber-GRACIELA-2.4G"; //Insira aqui o nome da sua rede Wi-Fi
char pass[] = "MyPassword"; //Insira aqui a senha da sua rede Wi-Fi
float temperature = 0;
float temperature2 = 0;
void setup() {
Serial.begin(9600); //Inicialização do Monitor Serial
Serial.println("BLYNK TEST");
Blynk.begin(auth, ssid, pass); //Inicia o Blynk
Serial.println("Conectado");
}
void loop() {
temperature += 0.1415;
temperature2 += 0.33085;
Blynk.run(); //Ativa o Blynk
Serial.println(temperature);
Blynk.virtualWrite(V0, temperature); //send temperature value to virtual pin 1
Serial.println(temperature2);
Blynk.virtualWrite(V1, temperature2); //send another value to virtual pin 2
}```
The monitor output says:
```ecting to JRFiber-GRACIELA-2.4G
Brownout detector was triggered
'⸮⸮i⸮⸮l⸮⸮$⸮ 4⸮BLYNK TEST
[26] Connecting to JRFiber-GRACIELA-2.4G
I am trying to use the code with a ESP32 DEV kit V1, Linux Mint 20.1, Arduino IDE 1.8.15. Please let me know if you guys need any further information.
A question: Do I have to configure any parameter on my modem/router in order to Blynk work properly on my device? Actually my ISP does not allow me to access the configs, so I am not supposed to change any of those params.
Thanks a lot for any help.
Rene.