/* Comment this out to disable prints and save space */
#define BLYNK_PRINT Serial
#include <ESP8266_Lib.h>
#include <BlynkSimpleShieldEsp8266.h>
// You should get Auth Token in the Blynk App.
// Go to the Project Settings (nut icon).
char auth[] = "5f6a31627c61xxxxxxxeda4823c";
// Your WiFi credentials.
// Set password to "" for open networks.
char ssid[] = "mi y2";
char pass[] = "dilkhush@20";
// Hardware Serial on Mega, Leonardo, Micro...
//#define EspSerial Serial1
// or Software Serial on Uno, Nano...
#include <SoftwareSerial.h>
SoftwareSerial EspSerial(2,3); // RX, TX
// Your ESP8266 baud rate:
#define ESP8266_BAUD 9600
ESP8266 wifi(&EspSerial);
WidgetLED led1(V1);
BlynkTimer timer;
// V1 LED Widget is blinking
void blinkLedWidget()
{
if (led1.getValue()) {
led1.off();
Serial.println("LED on V1: off");
} else {
led1.on();
Serial.println("LED on V1: on");
}
}
void setup()
{
// Debug console
Serial.begin(9600);
// Set ESP8266 baud rate
EspSerial.begin(ESP8266_BAUD);
delay(10);
Blynk.begin(auth, wifi, ssid, pass);
timer.setInterval(1000L, blinkLedWidget);
}
void loop()
{
Blynk.run();
timer.run();
}
sir please help me i have read many post about in esp8266 in the community but it doesn’t help me 
. iam facing the problem because as you see in picture there is no ping .i tried connecting to wifi many time all the time wifi connected but only one time i see the option of ping only once and after that time till now i have no ping option in serial monitor 
.i hope that my problem may be solved .i have firmware version 0.9.5.0 flashed in esp 8266 and using it with arduino .All at command works in 96000 baud rate. @GunnerTechTools @Costas
I fixed that as well but you might want to change it.
