[LED COLOR FAIL] With Widget Device Selector

[Gunner]

This is a year old topic… many changes since.

If you have an existing topic on this, then please keep commentary in there, if not, then please create one.

Although I suspect that you are simply sending a value that sets the intensity of the color to a very low value…AKA 1, when the range is from 0-255.

See here… different device but possibly same issue.

Eventor switch On on time is OK, as for the OFF part not OK

@wwhouseww OK, since I rarely use direct pin control, rather always Virtual pins and code, it took me a bit to figure out, but here is your issue… Using set pin to allows a range of numbers, as in PWM, so 0 is “ON” for your relay, but so is 1… and probably anything up to around 512… at which time there might be enough change to trip the breaker… use 1023 instead and that would set the pin fully HIGH or “OFF” for your relay. Or just use the easier option and use turn ON pin and turn OFF pin in…

Thank you.