HELP continuous reconnection

[distans]

@Gunner

Yes.

THANK YOU!

I’m still somewhat annoyed that the Blynk example browser still has a 1 Hz timer for the DHT11. It’s been proven over and over again that it’s too fast to work with Blynk (which I informed the founding fathers about in like 2017)!

According to myself some libraries are slower than others:

Blynk and While (Alternatives)

I think I found the culprit for the high latency! Since the sensors are very popular and widely used, others may find this to be of interest. If you Google DHT22, chances are you’ll end up at Adafruit’s homepage and consequently pick their library. In the DHT.cpp from their library you find this: `pinMode(_pin, INPUT_PULLUP);` and // Go into high impedence state to let pull-up raise data line level and // start the reading process. digitalWrite(_pin, HIGH); delay(250); This doesn’t…

And as always, who need to get a temperature reading every second? Unless your house is on fire, every 5 minutes is good enough