Ethernet shield

[Costas]

@Mic_Putignano take a look at this thread relating to navigating the Blynk blocking routine for a W5100:

Brown outs or reboots

I think that was probably because you were using the nasty Blynk.begin() function. Below is a sketch that compiles for a W5100 but it’s untested. You will need to enter your details for IP’s etc at lines 12 to 15. You might need to vary the 25 and 30s entries at lines 19 and 20. When your ENC arrives you will then need to switch to the UIP library version. // W5100NoBlock.ino for https://community.blynk.cc/t/brown-outs-or-reboots/16909 #define BLYNK_PRINT Serial #include <SPI.h> #include <Eth…