Hi friends. I cannot selecting BLE or Bluetooth widget in Blynk android.the project board is arduino 101 and smartphone is sony xperia z ultra with android 5.1.1
Check App permissions.
Permission already is allowed.
Well, as far as the App is concerned, the phone says it doesn’t have any such devices…
Try removing, reinstalling the App… confirm permissions and confirm that the BT radio is even turned on.
Googling your phone model, there seems to be lots of references to BT issues…
This message means that you have no devices in the project, that have Bluetooth connection type.
That would make sense…
@ErfanDL You can’t use what you don’t setup
However… does your Phone support BLE, or only BT?? I suspect it is only BT, while the Arduino101 is only BLE
I guess that device with Android 5.x should support BLE
Yes… finally found specs that, while don’t say BLE, do show 4.0 so should work…ish…
I setup the project with arduino 101, but BLE can’t be selectable. The phone is supporting BLE I use two smart watch supported with BLE and working without any problem.
Ok. I compiled an example for ESP32 BLE. I paired my smartphone with Blynk bluetooth device then going to the app and make a project with ESP32 Dev board but again bluetooth or BLE widget cant be selectable
You need to open your project’s settings, go to devices in it and add a new device with BLE connection type, or change your current device’s connection type (probably, from Wi-Fi) to BLE
I do it but nothing !
I’ve checked - it works fine.
If you want to add BLE widget:
If you want to add Bluetooth widget:
You screenshot of project’s settings shows that your device is configured with WiFi connection type
please forgive me. It was my mistake.
Thanks the problem is solved
A post was split to a new topic: Trying to connect a particle photon via a JDY 08 BLE bluetooth module to my Blynk