Blynk.edgent often sending a Nan value of DHT sensor

[dhimas]

i’am so sorry Mr.Pete i got hooked by this thread, and that right the default give me " 2 ".

@Troubleshooting Edgent Dynamic Provisioning Problems

As you can see, this uses GPIO0 (Pin D3) for the physical pushbutton switch, but GPIO4 (pin D2) for the LED. It also has the option to un-comment additional lines of code that allow an RGB or WS2812 RGB LED to be used.

i must look at this first.

@Troubleshooting Edgent Dynamic Provisioning Problems

#if defined(USE_NODE_MCU_BOARD) || defined(USE_WEMOS_D1_MINI)

  #define BOARD_BUTTON_PIN            0      <<<< The FLASH Button
  #define BOARD_BUTTON_ACTIVE_LOW     true   <<<< Pressing the button pulls the pin LOW

  #define BOARD_LED_PIN               2      <<<< The LED is connected to GPIO2 (D4)
  #define BOARD_LED_INVERSE           true   <<<< The LED lights when the pin is LOW
  #define BOARD_LED_BRIGHTNESS        255    <<<< Make the LED shine at max brightness when lit

i’m so sorry.