Problem with synchronizing pin states when re-launching the Blynk app (Particle Core)

[jtelos]

I think Im running the same problem described here in my implementation:

Output Button on analog port lose the state on iPhone App

Hi, I have a project where Im using the Blynk app with a relay board and Particle Photon. Because I need to control 16 outputs, I use a few digital and analog port as a digital OUTPUT. I have a random problem with the Blynk App. When I stop the dashboard or don’t use it for a few hours the status of a the buttons associate to analog ports change to “OFF” but are “ON” in the hardware. For example, I have 16 button turned ON, if I close the iPhone app, and open it again, a the ANALOG associate …

But The buttons who lose the sync in my case are only the ones connected to analog output pin.

I want to know if this was fixed or not?

Thanks