BLYNK
HOME       📲 GETTING STARTED       📗 DOCS       ❓HELP CENTER       👉 SKETCH BUILDER

Flash ESP 01 - problem

After flashing the ESP 01 firmware for blynk. I am getting continuously junk value in the serial monitor. I removed the power pin and plugged in to restart the ESP-01. Once I open the serial monitor(115200 baud) I see continuously junk value.

Note: The flash worked fine.

Try each of the available baud rates until what you see makes sense.

Pete.

After replacing the ESP-01, it worked. There was some issue with the hardware itself.

Thanks Pete