Ok. Do not bash me here. I am new to all of this, and I did a few tutorials and I have tested my project with regular code with the UNO and then again with the NANO. For some reason when I went to trying to setup the wifi, I started assigning the breadboard pin number, e.g, 5,6 for pins D2 and D3 with the Nano and this was likely the root of all my issues. I wouldn’t be surprised if was doing the same with the HC-08 ble module. I was pretty sure I tried troubleshooting this previously because all the topics say they are generic errors for improper connections but apparently that was not the case. Either way thanks for helping me through this.