Hi,
When i connect Blynk local server the cmd page shows like,
EVENT_CLOSE
InOut() - STOP
Disconnect() - OK
Connect("192.168.0.7", "9443") - OK
InOut() START
DSR is OFF
And when i login my blynk app the auth token didnt sent to my email It shows “Sorry, Server can’t talk right now”".
What is the solution and Thanks in Advance
@Nanthu To clarify, only change this server port to 8080 in your blynk-ser.bat (assuming Windows) file. The App still needs to be 9443 in your Custom Server setup.
@jbowser Please don’t confuse this issue… this OP is using the USB link, it works differently; The Port and Server IP are not in the Sketch, rather in the blynk-ser.bat (assuming Windows) file, with Blynk.begin(Serial, auth); only containing these two parameters…
When i changed my windows bat file port 9443 to 8080.It shows below
Connecting device at COM5 to 192.168.0.7:8080…
OpenC0C("\.\COM5", baud=9600, data=8, parity=no, stop=1) - OK
Connect(“192.168.0.7”, “8080”) - OK
InOut() START
DSR is OFF
and my blynk app port is 9443 only when i changed to 8080 it shows port in use…But still auth token not send to my mail and it shows “Sorry ,server cant talk right now”
Hi,
When I login in Blynk app the default server settings is blynk then I got auth token to my mail.
When use server settings is custom I didnt get auth token to my email. It shows “Sorry server cant talk right now”.